I removed the first led since it would be always on if there was no hard drive access. I bought some T1 3mm "bright" red leds for the bullets and soldered them to wire. Next time I will need to buy black wire too so I can tell which is the positive and negative, ended up using a sharpie marker to mark negative. I used the utility knife to widen this side of gov free credit report Bangor the hole. Perhaps I could have mounted them using T1 holders super glued to hole. my free credit report Here is my soldering job, I think it's pretty good for my first real job. you can see where I screwed up and cut the bullet led wires too short. Here you can see the complete hot glue job and the megaman logo installed. I used plastic from a floppy disk to cover the back of the cutout. One gov free credit report Bangor other thing I noticed after all that work is that I should have put the negative side on the open side of the cover. instant credit report As an earlier experiment showed you don't want the power supply's +5v line to hit the case.
I covered the whole backside with electrical tape anyway.
I make gov free credit report Bangor sure I have the power off when I add/remove this from the system. For some reason the video is slower then it should be, I assume due to gov free credit report Bangor compressing it. If you look at it, even at a slight angle you can't see the holes at all but the lights are quite visible. credit reports and scores
ไม่มีความคิดเห็น:
แสดงความคิดเห็น